Universal 12V Car Engine Ignition Start Stop Button System Starline Auto Alarm Remote Starter SUV PEK Keyless Entry System

Bullet Points:
1、Smart One-button Start: The remote alarm system comes with smart one-button start and is 12V universal for all the cars.
2、Reminder Sound: Set reminder sound, the sound and light will be anti-theft.
3、Keyless Entry: Carrying a smart key close to the vehicle about 2 meters, the system automatically recognizes and unlocks.
4、Remote Control Start: Remote warm-up in winter and remote air conditioning in summer.
5、Functional and Practical: The keyless entry starter is fully functional and practical, can be freely matched and purchased.
Features:
1. One-key start / stop
2. Remote start / stop
3. Intelligent handbrake detection
4. Smart oil pump start detection
5. Rear box opened remotely (requires the original car's own tail box motor)
6. Remote control car search (horn sounds, direction light flashes to prompt)
7. Roadside parking flashing light warning function
8. Remote unlocking / locking
9. PKE keyless comfort entry function, automatically unlock the car 1.5-3 meters away from the car, automatically lock the door 3-5 meters away from the car
10. PKE induction temporary shutdown function
11. RFID identification
12. Anti-theft alarm function (Illegal driving door, stepping on the foot brake triggers alarm prompt)
13. Motor engine lock function (the vehicle cannot be started in the car after the door is locked)
14. Automatically lock the door by stepping on the foot brake after starting, and automatically unlock when the flame is turned off
15. Start the automatic lock release, and automatically open the lock when the flame is turned off
16. Alarm notification for the original car horn (requires that the original car has a control line, and an alarm horn can be added)
17. Power-off memory
18. Emergency reset function
19. The remote control is turned on for 10 minutes and the flame is turned off regularly




Note : 
  Specifications:
Ambient temperature: -40c— + 80c; atmospheric pressure 86-106KPa
Relative humidity: 10% -95%
Working voltage: DC12V +/- 3V
High frequency: 433.92MHZ, low frequency: 125KHZ
Features: One-button start system, remote control preheating and cooling, PKE anti-theft device, comfortable entry
Applicable to models: 12V car

Please kindly Note:
 
If the original car was equipped with a steering wheel lock and  chip anti-theft , before to modify one-button start ,the car must be released from the original car steering wheel lock and chip anti-theft and then can be used normally
 
Specifications

Fit For:12V battery car, van, pickup truck, SUV, etc., general purpose products

Operating Voltage:12V±3V

Quiescent Current:less than 10mA

Working Frequency:433MHz

Features

-Q6C intelligent one key to start the system, using smart chips, can provide a key to start / flameout, convenient and simple.

-PKE keyless entry, automatic sensor switch lock function, near the car 2 meters, the automatic sensor unlock.

-There is a remote start / flameout, countdown ten minutes off function.

-Summer cool car, winter warm car, no longer bear the car when the uncomfortable.

-With the identity function, the remote control is not able to start normally.

Key Operation

-Do not press the brake, short press to open the ACC sound, then press the ''on'' dashboard, the indicator light flashes, then short press off, you can cycle operation.

-Brakes, short press, the system ignition start, light long light.

-When the flame is turned on, the brakes are short pressed and the system is turned off.

-Step on or not brakes, long press, the system can let go after the ignition, light long light

Package Included:
 

​1 x Host

2 x Remote Control Handle

1 x Start Button

2 x Sensing Antenna

1 x Start Harness

1 x Detection Harness

1 x Restore Button

1 x Manual

 

 

 Q&A :

1.How to find the ACC wire?

Please rearrange the 6P cable, after you twist the key to the first gear position (you can listen to music at this time), measure the line that has electricity on your original car is the ACC line.

2. For your 6p cable, but my original car is only 5p. what can i do ?
If your original car is a 5P line, the right connection is normally 1 power line, 1 ACC line, 2 ON lines, and 1 start line. If you didn't follow this step, it means you got wrong installation. pls recheck it again. and pls remember 2 ON lines need to distinguish which is ON1 line and which is ON2 line. If the two ON lines are always charged at the time of startup, you need to connect the two ON lines in parallel.

3. How to tell the wire ON1 and ON2?
If you test these two ON lines at startup, one of the two that always has power is the ON1 line. And If the other one has instant power is the ON2 wire.