EWS Modified Floding Remote Key 4 Button 315/433MHZ With 7935AA ID44 Chip for

With HU58 or HU92 Blade

With Remote/Electronics/Transponder chips/Battery

 

 

It fits with :

1998-2005 for 3 5 + 7 Series

1998-2005 for X5 Z3 Z4

2001-2004 01 02 03 04 for 330 330i

2001 2002 2003 2004 2005 for X5 Z3 Z4

2001-2004 for 525 525i

1998-2000 for X5 Z3 Z4

2003-2005 for 3,5,7 SERIES

2001-2004 for 3 SERIES

1998-1999 for 3,5,7 SERIES

1998-2000 for 325 325i 325ci + i ci xi

2001-2004 for 325 325i

for 325 330 318 525 530 540 E38 E39 E46 M5 X3 X5 E65

 

 

Frequency: 315MHZ OR 433MHZ
 
Chip ID: PCF7935AA  ID44 Chip
 

The keyblade needs to be cut at your local dealer or qualified locksmith.

 

BMW EWS System Programming Method :

 

BMW REMOTE KEY FOB PROGRAMMING INSTRUCTION FOR BMW "RUBBER" KEY

REMOTE CONTROL TRANSMITTER PROGRAMMING PROCEDURE FOR BMW - "RUBBER" KEY.
THESE INSTRUCTION ARE SUITABLE FOR BMW E46, E39, X3, X5 AND OTHERS PRODUCED TO 1999.
OEM PART NUMBER OF KEYS : 51218374929 / 66126955750 / 51218372844 / LX8FZV AND OTHERS.
NO TOOLS REQUIRED.

1. GET INTO THE CAR, CLOSE ALL DOORS AND INSERT THE KEY INTO THE IGNITION SWITCH.

2. SWITCH THE IGNITION LOCK BRIEFLY TO IGNITION LOCK POSITION 1 AND SWITCH OFF AGAIN.
    THE SWITCHING TIME MUST REMAIN UNDER 5 SECONDS.
3. REMOVE THE KEY FROM IGNITION SWITCH.
4. PRESS BUTTON #1 AND HOLD IN.
    You must remove the key from ignition switch and press & hold button #1 within 5 seconds of removal.
5. STILL PRESSING BUTTON #1 - PRESS BUTTON #2 THREE TIMES.
6. RELASE BUTTON #1. 
    LED 3 will flash slowly for a maximum of 10 seconds. 
    When done properly the doors will automatically lock and then unlock.
7. TEST REMOTE ( S ) TO ENSURE PROPER PROGRAMMING.  
 If the LED does not flash or the central locking system fails to respond, you must repeat the initialization procedure.
 
 If you possess additional transmitters for you vehicle (up to a maximum of 4 units) you must now initialize these as well.
 
 Be sure that no more than 30 seconds is allowed to elapse between the individual initialization procedures.
 
 Do not actuate the steering lock during this time.

 
 

​