Benz EIS ELV Adapter Alternative

Godiag Full Protocol OBD2 Jumper Cable Set

Introduction:

Full protocol OBD2 jumper is used to connect ECU for ECU programming via OBD2 way such as MPPS, FGTECH, KESSV2, BYSHUT, DISPROG, etc. Or connect ECU for key programming via Xhorse, CGDI and Autel key programmers.

The godiag universal jumper can be used to replace the Benz EIS EZS test cable set for xhorse vvdi mb tool and vvdi key tool plus to read Mercedes Benz EIS data.

The cable set can also be used with xhorse vvdi2/ vvdi bimtool pro to read VW Audi engine ECU data and PIN.
(Check operation videos in Video area)


Godiag Jumper Cable Functions:

1. Supports DC power supply

2. Support safety protection banana head super programming dedicated connection port power supply.

3. Independent GND4, GND5 [meet the needs of special ECU programming].

4. With boot GND4 clip, compatible with programming equipment such as MPPS, FGTECH, KESS V2.

5. With GND4 GND5 short-circuit switch [some ECUs need to be switched to short-circuit mode when programming].

Note: The switch of GND4-5 is normally pressed to make it light. When some ECUs need to be independently connected to GND4 and GND5, release the switch.
6. With ignition analog switch [equipped with 1 large and 2 small dedicated ignition cables].

7. Support standard obd2 full protocol connection [double K line, double CAN line], 3 large and 2 small power plugs, 4 large GND, 4 small GND.

8. Equipped with CAN protocol communication resistance.



Connection diagram of the dedicated programming power connector.



FGTECH programming connection diagram




MPPS ECU connection diagram


KESS V2 ECU connection diagram



What is the analog ignition switch?

After the ING ignition switch is pressed, the line marked with ING12V will have 12v, which is the analog ignition switch. Because when some devices read some ECUs, the device will prompt to turn on or off the ignition switch.

Package Includes:

1pc x Full protocol OBD2 jumper
3pcs x Electrical resistance